Here you'll create your very own Blade for your spyder.
For FREE
For this progect You'll need a mallet or hammer A nail with the tip broken off or a small tool to poke out a pin on your gun.
KNOCKING OUT THE PINS
First off all you have to remove the frame from the body. If you do not know how to do this ask in the forum. Then take your hammer and your small tool to knock out the pins. First you have to determine which side to do this on. Knock the pins on the side with no ridges like the one on the picture. Do not hit the ones with the ridges. They look like stars. You again want to tap the side with no stars. A few good wakes and you should be able to get it out. This also depends if you have a mechanicle trigger or electronic. If you have a mechanicle knock out both pins. If electronic you only have one pin :)
NOW...
That you got the trigger out you want to get sandpaper (Any type you have will do) Then when you sand your trigger down. ( now be careful when you sand. Be gentle becuase it may break)
YOUR DONE
Now when your done shaping the trigger like you want it put everything back into the gun just like you found it. Make sure the star sided is in the correct side like when you put them back in. Be careful and DO NOT RUSH IT.
